Acroprint Es 1000 Timeclock User Manual
Acroprint® ES1000 Electronic totalizing payroll recorder time clock ribbon in black/red color is made of plastic/polyester to render quality results. Ribbon is ideal for Acroprint® Models ET and ETC time stamps. The details of this User's Manual are subject to change without previous notification. This User's Manual has been prepared with the utmost care to cover all aspects of the time recorder's use. If you feel, however, that some explanations are inadequate, unclear, or difficult to understand, please do not hesitate to contact Acroprint.
General Service Instructions
Models 125 and 150 Recorders
To Remove Case Cover
1) Turn key one quarter turn clockwise.
2) Lift case cover up then forward.
3) Reverse procedure to replace cover.
To Set Time and/or Date
NOTE: Unless your recorder is equipped with
continental (0-23) hours, all PM hours on the time
card will be printed underscored (Ex.: 1:00). To
Make no exceptions.No one can predict if use of a child restraint will prevent injury or death in a particular crash. Make it a firm rule that the vehicle does not go until everyone is buckled up. If you always buckle your seat belt, your child will think it is the natural thing to do. Thank you for choosing this car seat, referred to throughout this manual as a child restraint.The DJG family is committed to creating a child restraint with the most comfort and convenience available today.Remember, parents are a child’s first teachers and examples.
change the time and/or date follow these steps:
1) Unplug recorder and remove Case Cover.
2) To Set Day/Date
A) Make sure current time setting is between
midnight and noon (see note above).
B) Push down and release Yellow Lever (see
Figure 1) to set correct day/date.
C)Plug in recorder and punch card to verify correct
setting. Repeat steps A-C if reading is incorrect
3) To Set Time
A) Push down and release Black Minute Lever
to set the correct time (see Figure 1). If
minute lever does not work, plug in recorder
and wait for minute hand to advance, then
unplug recorder and try lever again. DO NOT
MOVE CLOCK HANDS TO SET THE TIME.
4) To Set Month (if so equipped)
A) Turn Month Knob (see Figure 1) counter-
clockwise to select correct month.
B) Plug in recorder and punch card to verify correct
setting. Repeat steps A-B if reading is incorrect.
5) To Set Year (if so equipped)
A) Insert point of pen into spoke on side of year
wheel and rotate counter-clockwise.
B) Plug in recorder and punch card to verify correct
setting. Repeat steps A-B if reading is incorrect.
IMPORTANT NOTES
1) The date setting (if so equipped) MUST
be manually reset to the first of the
month each month, following any month
with less than 31 days.
2) The month and year settings (if so
equipped) MUST be manually reset
every month/year.
3) To reset your recorder after a power
failure follow the steps 1-5.
4) HINT: If clock is set slightly ahead of actual
time, you may unplug it until it matches the
correct time.
To Set Time and/or Date for Left Print Models
1) Unplug recorder and remove Case Cover.
2) To Set Day/Date
A) Follow the same steps as for standard models,
but note the different location of Yellow Day/Date
lever in Figure 2.
3) To Set Time
A) Follow the same steps as for standard models.
4) To Set Month (if so equipped)
A) Move Month Lever (see Figure 2) to extreme
left position then return slowly to right until an
audible 'click' is heard.
B) Plug in recorder and punch card to verify correct
setting. Repeat steps A-B if reading is incorrect.
5) To Set Year (if so equipped)
A) Note that year set lever is located at the rear
of the typehead assembly. Follow the same
steps as for setting the month on left print
models.
Figure 2
(left print models)
Month Lever
I2 I 2
3
4
5
6
7
8
9
I0 II
CROP R I
T
Acroprint Time Clock Time Clock
N
RALEIGH, N.C. USA
Black Minute
Lever
Yellow
Day/Date
Lever
Month Knob (turn counter-clockwise)
Figure 1
(cover removed)
I2 I 2
3
4
5
6
7
8
9
I0 II
CR OP R I
T
N
RALEIGH, N.C. USA
Black
Minute
Lever
Yellow
Day/Date
Lever
Note: Day/Date & Month levers
are shown in cut-away views.
Acroprint Es1000 Time Clock
The levers are behind the clock
dial.